Universal Tubs HDSI3060RWS Guide d'installation télécharger pdf (Page 17)

Universal Walk-In Bathtubs 5701 NW 35 Avenue Miami, FL 33142 PHONE: 877-360-4454 FAX: 866-560-1060 www.universaltubs.com

Page 15

OPERATING INSTRUCTIONS

The unit must be connected only to a supply circuit that is protected by a ground-fault circuit-interrupter (GFCI). Such a GFCI should

be provided by the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt

power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, there may be a ground current

flowing, indicating the possibility of an electric shock. Do not use this massage bathtub. Disconnect the jet massage bathtub and

have the problem corrected by a qualified service representative before using.

To reduce the risk of electrical shock, the dedicated electrical supply circuit(s) must be grounded. To do this, connect the third leg of

the 3-conductor wiring cable to the grounding terminal of the electrical service panel and run continuously to the green grounding

screw on the GFCI or electrical receptacle in the wiring compartment.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 25 26

Pas de commentaire

Universal Tubs HDSI3060RWS Guide d'installation Page 17